Products Category
Contact Us

Name: Cindy
Tel: +86-576-84407662
Fax: +86-576-84035875
Mobile: +86-13706578079
Add: North City of Economic Development Zone,Huangyan,Taizhou City,Zhejiang Province,China
Skype: cindy19880102
QQ: 464129895
E-mail: info@plastictoolmaker.com
skype: cindy19880102 QQ: 464129895

[Moulding problem solution] Jetting

Author : Date : 7/15/2014 8:58:28 PM
 Jetting

From the gate point, the surface of the plastic moulding exhibits a snaking, often rough or matt strand of polymer melt.

Jetting often occurs when the melt is directed from the gate into the open cavity at high local velocity.

Ideal conditions for jetting usually occur when the melt flows through a small gate into a thick section or is fired between the walls of the injection mould.


Solution:

         1. Reduce the speed of injection.

         2. Incorporate a obstacle in front of the gate like a pin.

         3. Enlarge the gate to reduce shear.

         4. Move the gate to an adjacent area where the melt is forced to flow around an obstacle or against a wall.

Chinese Deutsch Espanol Francais Italiano Portugues Japanese Korean Arabic Russian
Home | About Us | Products | SOLUTIONS | Video Show | Service | Feedback | Contact Us | SiteMap sitemap
Copyright © 2016 XS Plastic Mould Co., LTD All Rights Reserved