Products Category
Contact Us

Name: Cindy
Tel: +86-576-84407662
Fax: +86-576-84035875
Mobile: +86-13706578079
Add: North City of Economic Development Zone,Huangyan,Taizhou City,Zhejiang Province,China
Skype: cindy19880102
QQ: 464129895
E-mail: info@plastictoolmaker.com
skype: cindy19880102 QQ: 464129895

[Moulding problem solution] Ejector Marks

Author : Date : 7/15/2014 8:51:44 PM
 Ejector Marks

After ejection from the mould, ejector pins have clearly left visible marks on the surface of the moulding in the form of the moulding in the form of depressions,

differences in gloss or stress whitening.



Solution:

         1. Ensure ejectors finish flush with the surface of the mould.

         2. Optimize the changeover to hold pressure.

         3. If sink marks are visible on the ejector points, increase the hold pressure.

         4. If differences in gloss are visible on the ejector marks reduce the hold pressure.

         5. Reduce the injection speed to minimise injection pressure.

         6. Extend the cooling time and/or changeover time.

         7. Ensure accurate location and movement of ejector pins.

         8. Reduce the hold pressure.

         9. Reduce the temperature of the mould core.

        10. Use a mould release agent.

        11. Check the mould for undercuts and draft.

        12. Ensure adequate venting of the mould.

        13. Reduce the melt processing temperature.

        14. Install additional ejectors and/or enlarge the existing ones.

Chinese Deutsch Espanol Francais Italiano Portugues Japanese Korean Arabic Russian
Home | About Us | Products | SOLUTIONS | Video Show | Service | Feedback | Contact Us | SiteMap sitemap
Copyright © 2016 XS Plastic Mould Co., LTD All Rights Reserved